AJW UG2-K Concealed Snap Flange, 1.25" Diameter Grab Bar - Configuration K

Item normally ships out within 2-4 Weeks (excluding transit time). Specific options may or may not increase shipping time. For any reason, if there is a delay in shipping time we will notify you. Feel free to contact us if you have any concerns.

This product is currently not available for sale, please contact us for more information.

$63.08

?
?

Details: AJW UG2-K Concealed Snap Flange, 1.25" Diameter Grab Bar - Configuration K

Tubing

Fabricated of type 304 #18 ga stainless steel with a #4 satin finish. Available in 1¼" outside diameter. All bends are formed by an automatic mandrel bending process. All bars maintain a constant 1½" offset.

Flanges

Snap flanges are fabricated of 3" diameter,⅜" deep drawn type 304 #22 ga stainless steel with #4 satin finish to match tubing.

Strength

Bars with a projection no more than 5" off finished wall will sustain loads in excess of 900 lbs. When properly mounted. Bars with more than 5" projection will sustain a load of 250 lbs for 5 minutes when properly mounted.

Installation

Before installing grab bars, verify with all state and local codes for requirements on bar diameter and type finish. Recommended mounting heights for grab bars are 33" - 36" centerline above finished floor. All mounting of grab bars when possible should have in wall mounting back plates. Find centerline mounting points and place bar on line making sure to be on center. Transfer mounting points (3 per flange) to wall. Drill pilot holes and secure bar with proper anchors per application. Snap cover over mounting plate.

Available Model Numbers and Combinations

Model/SKUAttributes
UG2-K1632L Satin, Left Handed
UG2-K1632R Satin, Right Handed
UG2X-K1632L Peened, Left Handed
UG2X-K1632R Peened, Right Handed

Reviews

Write a review

AJW UG2-K Concealed Snap Flange, 1.25" Diameter Grab Bar - Configuration K

AJW UG2-K Concealed Snap Flange, 1.25" Diameter Grab Bar - Configuration K

More products from this category