> >>Browse Combinations

AJW UG2-G Concealed Snap Flange, 1.25" Diameter Grab Bar - Configuration G

Showing 1 - 4 of 4 items
  • Tubing: Fabricated of type 304 #18 ga stainless steel with a #4 satin finish. Available in 1¼" outside diameter. All bends are formed by an automatic mandrel bending process. All bars maintain a constant 1½" offset.
  • Flanges: Snap flanges are fabricated of 3" diameter,⅜" deep drawn type 304 #22 ga stainless steel with #4 satin finish to match tubing.
  • Strength: Bars with a projection no more than 5" off finished wall will sustain loads in excess of 900 lbs. When properly mounted. Bars with more than 5" projection will sustain a load of 250 lbs for 5 minutes when properly mounted.
  • Installation: Before installing grab bars, verify with all state and local codes for requirements on bar diameter and type finish. Recommended mounting heights for grab bars are 33" - 36" centerline above finished floor. All mounting of grab bars when possible should have in wall mounting back plates. Find centerline mounting points and place bar on line making sure to be on center. Transfer mounting points (3 per flange) to wall. Drill pilot holes and secure bar with proper anchors per application. Snap cover over mounting plate.