> >>>>AJW UG2-G UG2-G 54x36 Concealed Snap Flange, 1.25" Diameter Grab Bar - Configuration G
AJW UG2-G Concealed Snap Flange, 1.25" Diameter Grab Bar - Configuration G View larger

A&J Washroom

AJW UG2-G UG2-G 54x36 Concealed Snap Flange, 1.25" Diameter Grab Bar - Configuration G

UG2-G 54x36

Length
54" x 36"
Finish
Satin
edit options

This item ships via LTL (Less than truckload) freight.

Item normally ships out within 2-4 Weeks (excluding transit time). Specific options may or may not increase shipping time. For any reason, if there is a delay in shipping time we will notify you. Feel free to contact us if you have any concerns.

This product is currently not available for sale, please contact us for more information.

$82.56

?

Details: AJW UG2-G UG2-G 54x36 Concealed Snap Flange, 1.25" Diameter Grab Bar - Configuration G

  • Tubing: Fabricated of type 304 #18 ga stainless steel with a #4 satin finish. Available in 1¼" outside diameter. All bends are formed by an automatic mandrel bending process. All bars maintain a constant 1½" offset.
  • Flanges: Snap flanges are fabricated of 3" diameter,⅜" deep drawn type 304 #22 ga stainless steel with #4 satin finish to match tubing.
  • Strength: Bars with a projection no more than 5" off finished wall will sustain loads in excess of 900 lbs. When properly mounted. Bars with more than 5" projection will sustain a load of 250 lbs for 5 minutes when properly mounted.
  • Installation: Before installing grab bars, verify with all state and local codes for requirements on bar diameter and type finish. Recommended mounting heights for grab bars are 33" - 36" centerline above finished floor. All mounting of grab bars when possible should have in wall mounting back plates. Find centerline mounting points and place bar on line making sure to be on center. Transfer mounting points (3 per flange) to wall. Drill pilot holes and secure bar with proper anchors per application. Snap cover over mounting plate.

Available Model Numbers and Combinations

Model/SKUAttributes
UG2-G 36x24 36" x 24", Satin
UG2-G 54x36 54" x 36", Satin
UG2X-G 36x24 36" x 24", Peened
UG2X-G 54x36 54" x 36", Peened

Reviews

Write a review

AJW UG2-G UG2-G 54x36 Concealed Snap Flange, 1.25" Diameter Grab Bar - Configuration G

AJW UG2-G UG2-G 54x36 Concealed Snap Flange, 1.25" Diameter Grab Bar - Configuration G

More products from this category