> >>Browse Combinations

Select SL306 Half Mortise Pin & Barrel Continuous Hinge, Satin Stainless Steel

Showing 1 - 5 of 5 items

Stainless steel half mortise hinge with edge guard. Mounts on frame face and door edge. Tamper-resistant frame leaf cover. For 1-3/4" doors weighing up to 600 lb., 48" max. door width. SL306 pin & barrel continuous hinges are BHMA Grade 1 certified.

Specifications

Material
14 gauge 304 stainless steel barrel with 3/16" diameter 304 stainless pin. Long-life nylon medical bearings
Lengths
79", 83", 85", 95" and 119" lengths standard for nominal door heights. Custom lengths are available
Finish
US32D satin stainless steel (630)
Closers
Conventional overhead surface, concealed sliding arm overhead or floor closers may be used with SELECT hinges. Pivot-type floor closers (with a fixed, conflicting center pivot) must be replaced

Load/Frequency

For 1-3/4"doors, 48" wide (max.), weighing up to 400 lb. (medium-frequency) without frame or door reinforcement; up to 600 lb. (low-frequency) without frame or door reinforcement.

SL306 Hinge Screw Count

HINGE LENGTHDOOR SCREWSFRAME SCREWS
79"1813
83"2114
85"1814
95"2316
119"2720

Options

UL® Labeled Fire Rating

For use on single-mounted doors, up to 3 hours for hollow metal doors, 1-1/2 hours for hollow metal and composite core wood fire doors, and 20 minutes for wood doors.

Dust-Free (Medical)

  • Flanged double bearings are standard on all SELECT Pin & Barrel continuous hinges except Toilet Partition hinges.
  • Prevent metal-to-metal contact for longer hinge life
  • Eliminate dust for "clean room" applications.

Security Studs

Stainless steel studs are mounted to frame leaf, door leaf is drilled to accommodate studs. 3 studs are required for hinge lengths up to 85", 4 studs are required for hinges longer than 85". Handing required. Door and frame must be specially prepared to accommodate security studs.

Blank Hinge

Holes are omitted for welded installations.

Preparation & Accessories

Electrical

Feature

  • 3-hour Fire Rating

Downloads