> >>Browse Combinations

Select SL71 Concealed Safety Geared Continuous Hinge

Showing 1 - 4 of 4 items

Safety hinge (when used without a frame stop). Provides clearance sufficient to avoid entrapment of fingers. Flush mounted (no door inset). For 1-3/4" doors. SL71 HD geared continuous hinges are BHMA Grade 1 certified.

Specifications

Material
Extruded 6063 T6 aluminum alloy with selflubricating polyester thrust bearings
Lengths
83"and 95" lengths standard for nominal door heights. Hinges can be cut to shorter lengths. Longer hinges are not available
Finishes
All SL71 hinges are stocked in Clear and Dark Bronze anodized aluminum. Custom anodized or painted finishes are available. Product painted or anodized in the field voids the SELECT hinge warranty
Closers
Conventional overhead surface, concealed sliding arm overhead or floor closers may be used with SELECT hinges. Pivot-type floor closers (with a fixed, conflicting center pivot) must be replaced

Load/Frequency Rating

Heavy Duty
Tested per BHMA standards. Up to 200 lb. doors (high-frequency) and up to 400 lb. doors (medium-frequency) without frame or door reinforcement; up to 600 lb. doors (low-frequency) with the use of Rivnuts in the frame and door

For 1-3/4" doors. 48" max. door width in 16 gauge hollow metal (min.) or 1/8" aluminum (min.).

SL71 Hinge Screw Count

HINGE LENGTH & DUTY RATINGDOOR SCREWSFRAME SCREWS
83" HD1919
95" HD2121

Options

Header Gap Prep

No more shimming! Door leaf trimmed 1/8" at the top and bottom to incorporate clearance required for installation. No handing required; available on all models.

Security Option

Non-removable bearing added at top of hinge to prevent material from falling into the opening between cap and gears. Hinge must be installed with security bearing at top of door. Handing required, except for SL11, SL27, SL38 and SL40. Not available with Hospital Tip.

Tamper-Resistant Hinge

Entire hinge prepared with set screws installed in every other bearing and tightened against inside of gear cap for additional security against tampering.

Geared Hinge Fasteners

SDTF
12-24 × 3/4", Self-Drilling, Thread-Forming, 410 SS Screws, Phillips Undercut Flathead
TF
12-24 × 1/2", Thread-Forming, 410 SS Screws, Phillips Undercut Flathead (Pilot hole required)
WD
12-14 × 1-1/2", 410 SS Wood Screws
WD/SDTF
12-14 × 1-1/2", 410 SS Wood Screws and 12-24 × 3/4", Self-Drilling, Thread-Forming, 410 SS Screws
WD/TF
12-14 × 1-1/2", 410 SS Wood Screws and 12-24 ×-1/2", Thread-Forming, 410 SS Screws

Preparation & Accessories

Hospital Tip

TIPIT® Ligature-Resistant Hospital Tip

Downloads