View larger

Pemko S776_ 6 Fin Adhesive Perimeter Gasketing

Model: S776BL

Order $500 worth of Pemko Products and get 30% OFF!

Write a review

Item is normally shipped within 2-3 weeks from manufacturer. Specific options may or may not increase shipping time. For any reason, if there is a delay in shipping time we will notify you. Feel free to contact us if you have any concerns.

Details: Pemko S776_ 6 Fin Adhesive Perimeter Gasketing

We offer a variety of adhesive-backed smoke and fire gasketing and edge sealing systems, including SiliconSeal, PemkoPrene®, silicone triple-fin gasketing, Hot Smoke Seal intumescent edge sealing for Category B doors and combination fire and smoke gasketing. Gasketing is tested for sound resistance, smoke and draft control, fire rating, positive pressure, airworthiness and is BHMA certified.

Adhesive Gasketing

All adhesive gaskets have a limited shelf life. These products must be used within 6 months of purchase and must be stored between 50 degrees (F) and 100 degrees (F).
Thoroughly clean the frame with the enclosed cleansing towelette to remove grease, dust or cleanser build-up. Before installation, wait for frame surface to completely dry (evaporate). Some hospital environments have wax or anti-bacterial cleanser build-up. As an alternative or substitute cleanser, use isopropyl (rubbing) alcohol. Note: Mineral spirits or other petroleum based cleaning products should NOT be used.
If frames are too cold (below 50ºF) or too hot (above 100ºF) adhesion may be impaired.
Installation should take place after construction is completed, flooring is installed and final cleaning is completed.
Paint on frame must be cured for at least 5-7 days. Paint cannot be wet under dry surface when gaskets are pressed on. Avoid quick-dry primers, which leave a powdery surface preventing sufficient adhesion. When applying to a wood frame, the surface must be non-porous and sealed. Follow standard industry guidelines on sealed wood frames and/or rough surface before applying. Note: Anti-bacterial, anti-fungal or silicone additives in paint may inhibit adhesion.
Do NOT stretch material. Product can retract or shrink if stretched.
Use very firm, perpendicular pressure when applying. Use wallpaper seam roller to reinforce adhesion after applying.
Do not stretch material when using seam roller. Run roller with up and down motions.
Double check adhesion after 2-3 hours before leaving job overnight.
If gaskets separate from the frame, press again with firm pressure in place. If adhesive strip is exposed, airborne dust may impede adhesion. Replacement may be necessary.
Application at header can be awkward due to overhead condition. Be sure to apply enough pressure.
Adhesion takes delayed set. Immediate removal and resetting can be done if error occurs in initial placement. DO NOT reset after one hour. Full set is reached in 24 hours.

Pemko S776_6

AVAILABLE FINISHES: BL
AVAILABLE LENGTHS: 17', 18', 20', 21', 25', 30'
ANSI: R0E154, R0E155
Designed for hollow metal and wood meeting stile applications
Seal begins compressing at 3/8"; compresses to seal up to a 1/16" gap

Pemko Warranty